Sliding Glass Door Weep Hole & Drainage Repair in Orlando, FL
Fast, honest weep holes in sliding glass door for homes and businesses in Orlando. 5.0-star rated on Google.
Sliding Glass Door Weep Hole Repair in Orlando
Weep holes in sliding glass doors are the small slots along the bottom track and the outside face of the frame, and their only job is to let water back out. When they clog, rain that blows into the track has nowhere to go, so it backs up, sits against the sill and eventually finds its way onto your floor. If you get a puddle inside after a storm but the glass and seals look fine, blocked weep holes are the usual reason.
From College Park bungalows to new builds near Lake Nona and the tourist corridor, Orlando homes lean hard on their patio doors year-round. Heat, humidity and daily use wear out rollers and tracks faster here than almost anywhere.
In Central Florida this is a seasonal problem. Wind-driven rain pushes water and grit into the track together, the grit settles into the drainage path, and by the middle of storm season the holes are packed. We clear the drainage path, check that the flaps or baffles behind the holes still open, and look for the two things that make clogging worse: a sill that has lost its slope and a bottom track holding standing water because the panel is sitting too low. We’re based right here in Orlando — no trip fees from out of town, no guessing about local door types.
Get a Free Quote
Signs you need sliding door repair in Orlando
These are the six problems behind almost every sliding door repair call we get in Orlando — and every one of them is fixable without replacing the door.
Sliding Glass Door Weep Hole Repair services
Drainage path cleared
The weep slots and the channel feeding them cleaned out end to end, not just poked open.
Weep flaps and baffles checked
The small covers behind the holes have to swing freely, or the water still cannot leave.
Track cleaned to the bare channel
Packed grit removed so the track drains the way it was built to.
Sill and threshold inspected
We look for lost slope and damaged sill sections that keep water sitting inside.
Panel height checked
A door riding low can dam the track, so we confirm the panel clears the drainage path.
Seal and sweep condition reported
If the bottom sweep is letting water in faster than it drains, you will hear about it.
What customers say
Sliding Glass Door Weep Hole Repair FAQs
Where are the weep holes on a sliding glass door?
Look at the outside face of the frame right at the bottom, usually near each end of the sill and sometimes in the middle on a wide door. They are narrow slots, often with a small plastic flap over them. There is a matching opening inside the bottom track that feeds them. Both ends of that path have to be clear for the door to drain.
How do I clean out blocked weep holes myself?
Vacuum the bottom track first so you are not pushing debris further in, then work a thin flexible tool through the slot — a zip tie or a length of trimmer line is ideal — to break up the packed grit. Flush with a little water and watch whether it runs out the outside face. Avoid drilling or forcing anything rigid through: it is easy to damage the flap or the drainage channel behind it.
Should water be sitting in my sliding door track?
Not for long. A little water in the track during heavy rain is normal and expected — that is what the track is for. It should drain away within a few minutes of the rain stopping. Water still standing there hours or days later means the drainage path is blocked or the sill has lost its slope.
How much does weep hole and drainage repair cost in Orlando?
It depends on what is causing it — clearing a packed drainage path is a very different job from repairing a damaged sill section. Tell us what you are seeing over the phone and we will give you a free ballpark first, then confirm the exact price on-site in writing before any work starts.
Can blocked weep holes damage my door or floor?
Over time, yes. Water sitting against the frame works on whatever is next to it — flooring, trim, subfloor and, on some doors, the bottom rail itself. The drainage problem is cheap to deal with; the water damage it causes is not, which is why it is worth clearing before storm season rather than after.
Do you handle weep holes on all sliding door brands?
Yes. Drainage design varies between PGT, MI, Andersen, Milgard, CGI and the unbranded builder doors we see across Central Florida — the number of slots, whether there are flaps, and how the internal channel runs. The principle is the same on all of them: find the full path and make sure water can leave.
Why weep holes in sliding glass doors matter so much in Central Florida
Most people never notice weep holes until there is water on the floor. A sliding glass door is not built to keep every drop out of the track — it is built to let water in and then drain it straight back out again. The bottom track is a channel, the weep holes are the exit, and the whole system depends on that exit staying clear. Block it and the channel becomes a trough that eventually overflows to the inside.
Orlando makes this worse than most places for a simple reason: our rain arrives sideways. Afternoon storms through the summer drive water into the track under pressure, and they carry grit, mulch and pollen in with it. The water leaves; the grit does not. By August a door that drained perfectly in April can be holding standing water for days after every storm.
Pool decks and screen enclosures
Doors opening onto a pool deck take a double hit. Deck sand and pool chemistry wash into the track constantly, and a screen enclosure that breaks up the wind does nothing to stop water reaching the door. These are the doors we most often find with the drainage path fully packed rather than partly restricted.
Doors under a short overhang
A lot of Central Florida homes have very little roof overhang above the patio door. There is nothing to break the rain before it hits the frame, so the track sees the full volume every storm. These doors need their drainage checked more often than a door tucked under a deep lanai, not because they are built differently but because they are simply working harder.
Older frames that have lost their slope
The sill under a sliding door is supposed to fall very slightly toward the outside. On older installations, and on doors that have been reset at some point, that slope can be gone — and then even perfectly clear weep holes will not drain the last of the water. This is the case where clearing the holes helps but does not fully solve it, and we will tell you if that is what we are looking at rather than clearing it twice.
Weep flaps that have gone brittle
Many doors have a small plastic flap over each exterior weep hole — it swings open to let water out and falls shut to keep insects and wind-driven rain from coming back in. After years of Florida UV those flaps go brittle. They either break off, which leaves an open route inside for ants, or they seize shut, which blocks the drainage completely even though the hole itself is clear. Both are easy to miss from indoors.
How we clear and repair door drainage
1. Find the whole path, not just the hole
The visible slot on the outside of the frame is only the end of it. Behind it runs a channel that collects water from the length of the track. Poking the outside slot open can produce a satisfying trickle and still leave most of the path packed, which is why the problem so often comes back within a month. We work the full run.
2. Vacuum first, flush second
Dry debris comes out with a vacuum before any water goes in. Flushing a packed track just turns the grit into a paste and pushes it deeper into the channel. Once the loose material is gone we clear the channel itself, then flush and watch where the water actually exits.
3. Check the flaps and baffles
Every weep opening gets checked for a flap that still moves. Brittle or missing flaps get reported, and where a replacement part exists for that door we can fit it. Where one does not, we will tell you that honestly rather than improvising something that will not last a season.
4. Confirm the panel is not damming the track
A door sitting low on worn rollers can bridge the track closely enough to hold water behind it, which produces exactly the same puddle as a blocked weep hole. We check panel height as part of every drainage call so you are not paying to clear holes that were never the problem.
5. Report what we cannot fix in one visit
Damaged sill sections, lost slope and water that has already reached the flooring are bigger jobs than a drainage clear. If that is what is going on we will show you, explain the options, and flag any special-order parts upfront rather than surprising you later.
We clear and repair sliding door drainage across Orlando and Central Florida, including Dr. Phillips, Windermere, Winter Park, Baldwin Park, College Park, MetroWest, Lake Nona, Hunter’s Creek, Conway, Avalon Park and Waterford Lakes. If water is coming past the panel rather than backing up out of the track, the problem is the seals — see weatherstripping and seal replacement. If the sill or lower frame is damaged rather than blocked, see frame repair, and if the panel is riding low in the track, adjustment or roller replacement is where to start. We are a licensed and insured, family-owned Orlando company rated 5.0 stars across 200+ Google reviews, and every part we install carries a 2-year warranty.
Need your door fixed in Orlando?
Call now for a free ballpark estimate over the phone.
Call (407) 900-9412